Genesis Check Engine Light

Please wait while the page loads...

Is it safe to drive your Genesis with the check engine light on?

If the check engine light is flashing, this means that there is a serious issue and it is recommended to service your Genesis expeditiously. This question is not immensely simple because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is generally indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more serious problem. Call the experts at Larry H. Miller Genesis of Albuquerque by dialing 5055915215 so you can describe the issues. Or decrease your speed and bring your Genesis to our certified mechanics as shortly as possible.

Check Engine Light Service Genesis

What do you do when you’re driving along in your Genesis and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Genesis owners, your heart sinks drastically because you may have exactly idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep, calm breath and realize the light coming on doesn’t mean you have to pull the vehicle over to the side of the road and call a tow truck, but it is advised that you get your Genesis checked swiftly. Ignoring that warning could end up causing major, considerable damage to costly engine components.

When your Genesis 's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that can promptly identify the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Genesis auto repair mechanics at Larry H. Miller Genesis of Albuquerque. There are again a number of comparatively inexpensive code readers that are designed for do-it-yourselfers, should you pick that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to determine the absolutely correct issue and repair it.

Will the check engine light reset itself?

The check engine light on your Genesis will usually shut itself off if the issue or code that caused it to turn on is fixed. For instance, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will expeditiously turn itself off. Also, if your catalytic converter is working perfectly, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Genesis light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Larry H. Miller Genesis of Albuquerque so the light and code can be double-checked and reset.

What Does the Check Engine Light Mean?

One of the most ordinarily misunderstood lights or indicators in your Genesis is the check engine light. The check engine light is part of the crucial onboard diagnostics system, and displays in a wide range of different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your car. Onboard computers increasingly have controlled and monitored car performance since the 80s and do a wide range of things for your Genesis. Some of these essential duties include ignition timing, controlling engine speed, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can mean an assortment of different things. It can be as simple as your gas cap being loose or as perilous as engine knocking. If your check engine light is on in your Genesis, contact Larry H. Miller Genesis of Albuquerque . Our Genesis service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing. Contact Larry H. Miller Genesis of Albuquerque today!

Genesis Check Engine Light

If the check engine light in your Genesis starts flashing, that means that the problem needs attention swiftly and your Genesis should be brought in expeditiously. A flashing light reveals that the problem is extremely serious and if not taken care of swiftly may result in major and serious damage to the car. This blinking light ordinarily reveals a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can rapidly raise the temperature of the catalytic converter to a point where damage is likely, requiring an pricey and extensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can specifically be the cause. A faulty, old or dirty spark plug can cause the engine to misfire. If the problem is totally ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a exceptionally pricey repair. If your check engine light is repeatedly flashing, please contact our team of automotive experts at Larry H. Miller Genesis of Albuquerque promptly by calling 5055915215.

Genesis Check Engine Light Flashing

Although there are countless potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are many common causes including something as simple as a loose gas cap. Other mostly common reasons for a Check Engine Light are faulty emissions control part, damaged head gasket, a malfunction with the fuel injection system, dirty mass airflow sensor, broken oxygen sensor, or faulty spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Genesis Certified Technicians and the certified service protocol to isolate the root problem and absolutely repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Genesis issue was totally fixed.

Every Genesis was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the car on its essential systems. The rapid sensors are continually detecting conditions while sending crucial data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, sadly that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Larry H. Miller Genesis of Albuquerque provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Extremely Qualified Service professional.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not perfectly tightened to a more serious failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it good to get the proper code reading and diagnosis. The average cost for a check engine light diagnosis & testing is usually between $88 and $111. The good news, Larry H. Miller Genesis of Albuquerque offers totally complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light.

Genesis Check Engine Light Codes

The check engine light turning on can be quite intimidating, exceptionally to see that little light on your vehicle’s dashboard suddenly illuminate, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, still known as the OBD (on-board computer diagnostic system) in your. There are hundreds of different codes that your check engine light can properly represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you advantageous knowledge about your car and will still allow that crucial Check Engine Light to do what it is genuinely supposed to do: be your guide. Unfortunately, clear and helpful car symptoms do not repeatedly accompany an illuminated Check Engine Light. Since there are hundreds of conceivable OBD codes, there are still hundreds of conceivable reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Emissions controls issues
  • Computer output circuit issues
  • Ignition system faults
  • Old Battery
  • Bad Spark Plugs
  • O2 Sensor
  • Fuel and air metering systems problems
  • Transmission issues

This is why it is essential for someone who does not have a lot of prevailing automotive knowledge to not assume what a code means. If the engine light comes on due to a serious concern, you risk damaging your car further by not repairing the issue right away. Call Larry H. Miller Genesis of Albuquerque at 5055915215 today or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out instantly by a skillful certified Genesis mechanic.

What could cause the check engine light to come on in a Genesis?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Likewise, the check engine light could likewise be a warning of an essential problem that could cause serious damage to your engine and come with a hefty and pricey repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady and continuous glow usually means something less serious but a flashing check engine light signifies that your vehicle’s engine is in significant trouble and helpful service is necessary expeditiously. If your check engine light is flashing in your Genesis, we highly advise not to drive the vehicle and schedule Genesis service today. Below is a list of the most common reasons your check engine light can come on:

  • Issues with any aftermarket items. An aftermarket alarm, exhaust or other item can wreak extreme havoc on your Genesis if it’s not installed accurately. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the car from starting. If these issues sound familiar, bring your to Genesis and have our team of talented certified mechanics ensure that your aftermarket items were installed perfectly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might cost a little bit more but could help you save considerably from having to get poor work and damage caused by poor installation work corrected.
  • New Spark Plugs or Plug Wires are necessary for your Genesis. The spark plugs are the part of your engine that ignites the air/fuel combination in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run smooth. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience a conspicuous poor performance and decreased power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, leading to more expensive repairs.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your Genesis ’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is normally caused by repeatedly neglected maintenance, which is why Larry H. Miller Genesis of Albuquerque offers a complimentary multi-point check with each Genesis service. If you have an issue with your catalytic converter and don't get it repaired, your Genesis will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your vehicle may run at a higher temperature, too, which can cause other perilous problems from overheating.
  • One of the most common and frequent cause is that your Genesis gas cap is loose, damaged or missing. The gas cap for your Genesis serves different purposes. It prevents perilous gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a damaged fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump and be more costly. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on immediately after you put gas in your Genesis, first thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Genesis is what determines how much fuel is necessary to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to certain changes, like altitude. If your Genesis is having trouble starting, idling rough or has a sudden fast change in the position of the throttle pedal, this could be a critical sign of a damaged mass airflow sensor.
  • Your Genesis has a vacuum leak. Each Genesis has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to intense heat or extreme cold.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns more rapidly and your car will be less efficient when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A damaged sensor can not only affect your miles per gallon, but it can cause significant damage to your catalytic converter and your Genesis 's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the explicitly correct combination of air and fuel that enters the cylinders in your engine. A damaged O2 sensor can also cause a vehicle to fail an emissions test.
  • The battery is low or dead. The battery in your Genesis is each critical. Without a vehicle battery, your vehicle won’t start, light up the road ahead, play the radio or charge your phone. Today’s vehicle batteries last much longer than they did a few decades ago, and they don't really require maintenance. The price of a new one depends on the type of Genesis you drive, but check our current service coupons and specials.

How many miles can you drive with the check engine light?

Since each check engine code has its own level of severity, it is typically difficult to predict how many miles you can be safe in driving with the warning light on. If you check engine light is flashing, we propose that you pull over and contact Larry H. Miller Genesis of Albuquerque to help determine if your vehicle is safe to drive in or if we propose a tow truck. It could be anything from a bad sensor to plug wires needing to be replaced. The safest bet is to decipher the code and then plan your strategy accordingly.